| |
| Ribbon Cone Angel |
 Materials:
- 33" Arabesque Ribbon
- 15" Glitteredge Ribbon
- 15" Glitter Cord
- 1 Ribbon Rose
- 9" 4mm Pearls
- 1 Irridesent Ball
- Wire
Instructions:
- Cut arabesque ribbon into six 5 1/2" lengths. Trim the ends of each
piece at an angle. Hold the ribbon with wrong side facing you and fold
into a cone. Fold up to the points and glue together. Repeat for all
three pieces.
- Glue three cones together matching points. Glue a fourth cone half
way into middle of centre cone of the three. Glue remaining two cones
with open edges facing down, behind the three cones for the wings. Cut
stem from ball and glue to centre of three cones for head.
- Make a 4 loop bow from the glitteredge ribbon. Glue to neck of angel.
Use 10" of glitter cord to make a shoelace bow. Glue to centre of bow.
- Cut and glue 4" of pearls around ball for halo. Fold remaining pearls
in half and glue to centre of bows. Glue rose to centre. Glue remaining
glitter cord to back for hanger.
This craft project was submitted by Viman Arts
& Crafts Ltd.
1150 Meyerside Drive
Mississauga, Ontario, L5T 1J4 |
|
